Funny how the Strelets cavalry has worked out isn't it?!! If only it was as easy as swapping horses!
If the fit between the WSS horses masters did work with the Napoleonic troopers, Strelets could then just adjust the equipment/saddle/shabraque etc to be more suitable for the Napoleonic regiment.
However, if the WSS troopers were to fit the Napoleonic horse masters better....they would then be cursed with the ugly horses instead!!
Why didn't Strelets just test the fit between rider/horse properly before going into full production??!
Sometimes it feels like there is a bit of lazyness that creeps in or a lack of care among some of the sets.
The Napoleonic horses clearly didnt look great so why not say to the sculptor "sorry but these need to be better", especially when they were going to be reused for multiple sets, meaning all such sets were tarnished with the poor horses. Surely someone examines them before moving to the next production stage??
Then the same goes for the WSS cavalry. Test the fit. If you know its going to be really tight (or on the "flipside"- too loose), dont just go full steam ahead regardless, adjust it so that it works.
Such issues can make the difference in sets being very popular or not selling very well. If its a timing/deadline issue for cranking out so many sets, I personally think getting the sets right & of a high quality is much better than quantity. Strelets could take an extra month or two on working on a set & still release sets quicker than their competitors!!
I don't really know what's the problem here with the production. Italeri (before the overall quality deteriorated), Revell and Zvezda always produced cavalry sets that provided an almost perfect fit between horse and rider. So it can't be that difficult. And to force the customer to cut away excess plastic be it flash or whatever to get a satisfactory product isn't exactly a very good idea. Fumbling with a sharp knife or a razor on a 20mm figure get's a little risky with old age and there's a good chance that someone get's hurt - usually the miniature 😜 - so it's not one of my favorite steps in modelling.