Can anyone recommend some good, lightweight, one piece wheels to fit my Mallock. I was going to use Compomotive CXR's but they no longer make 10" rears.

What about Revolution's ?

Revolutions taper and won't fit over front brakes apparently.

I'd suggest that you might struggle to get one piece wheels that will give you sufficient clearance. I have looked into this previously.Three piece should do the trick though, Mike Barnby (MB Engineering in Kent) might be best to advise? They do a good range of 13" wheels like Dymag replicas, but they are 3-piece. Regards

I’ve used MB wheels for some years and agree that they are good.

The Revolution split rims wil fit, i use them with the AP cp 3228 brakes

I’m sure they do Onno
Revolution split rims went out of production many years ago.
Tooling for the centres no longer exists. I believe MB rims fit the centres if you can find any second hand.

Thank you all for the advice.

Morris get some 22" Scania wheels should really suit your car
:kissing_smiling_eyes:

alternatively, use Evo Corse Mg rims per the Vision . Oh, sorry you can't do that as they are centre bolt fixing. You'll just have to carry on with your 16 nuts instead. sorry. That or buy the whole car to go with them:grimacing: :sunglasses:

Oh I see, the centre lock wheel gang are bullying me.....

Don't worry Morris. No-one is daft enough to bully a man with 16 nuts